Today's News / Transportation Safety

Propulsion failure caused ferry to crash into NY terminal, says NTSB

National Transportation Safety BoardThe National Transportation Safety Board (NTSB) has determined that a May, 2010 accident involving a ferry striking a terminal occurred when the ferry lost propulsion control of one its two cycloidal propellers as the vessel approached St. George terminal, Staten Island, New York. The loss of propulsion control resulted from a solenoid failure in one of the vessel’s propulsion control panels. The crewmembers on board the 310-foot-long Andrew J. Barberi were unaware that the propeller failed to respond to their commands until seconds before the ferry struck the terminal. A total of 266 persons, including 244 passengers, were on board the vessel. As a result of the accident, three passengers were seriously injured and more than 40 passengers and crew reported minor injuries.

The Andrew J. Barberi, which has a capacity of nearly 6,000 passengers, was not equipped with or required to have an alarm to alert the pilothouse crewmembers to the loss of propulsion control. This type of alarm would have given the crew additional time to respond. As a result, the National Transportation Safety Board (NTSB) recommends that U.S. passenger vessels with controllable pitch propulsion, including cycloidal propulsion—which the Andrew J. Barberi had—be equipped with alarms that audibly and visually alert operators when the propeller fails to respond to commands.

The Andrew J. Barberi was also involved in an accident in 2003, in which 11 people died and 70 people were injured. Subsequent to that accident and in response to NTSB safety recommendations, the vessel operator—the New York City Department of Transportation (NYC DOT) Ferry Division—implemented a safety management system (SMS) and trained its personnel in it. A SMS in the marine industry is a structured and documented system developed to enhance safe vessel operation, ensure compliance with regulatory requirements, prevent injury or loss of life, and avoid environmental pollution.

“The bad news is that the Barberi experienced an unanticipated and unusual failure in its propulsion system,” said NTSB Chairman Deborah A.P. Hersman. “The good news is that no lives were lost and our investigation showed positive safety improvements following the 2003 accident, in particular the NYC DOT Ferry Division implemented an industry-leading safety management system.”

The NTSB recommends that all U.S.-flag passenger vessels implement safety management systems.

A synopsis of the NTSB report, including the probable cause, findings, and a complete list of the safety recommendations, is available on the NTSB website.

Did you enjoy this article? Click here to subscribe to ISHN.

You must login or register in order to post a comment.

Multimedia

Videos

Image Galleries

ISHN's Favorite Cover Images

Take a look at some of our favorite cover images!
6/5/13 2:00 pm EST

A Safety Manager’s Guide to Dust Compliance

On demand This webinar will provide an overview of the standards that are providing safety managers a blueprint for compliance. During the NFPA Standards review component, NFPA 652, NFPA 654, NFPA 61 and other relevant Combustible Dust and Combustible Metals Dust Standards will be highlighted and discussed.

THE MAGAZINE

ISHN Magazine

ISHN June 2013 cover

2013 June

ISHN's June issue features a number of articles on heat stress, fall protection systems, safety management, and body protection tips.

Table Of Contents Subscribe

THE ISHN STORE

ANSI/ASSE A10.1-2011 Pre-Project & Pre-Task Safety and Health Planning

This standard establishes the elements and activities for pre-project and pre-task safety and health planning in construction.

More Products

Clear Seas Research

Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications,Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.

ISHN Webinars are an easy, effective and convenient way to get educated and informed on the latest industry trends and topics. All Webinars are FREE unless indicated. For more information, check out our Events page!

STAY CONNECTED

Facebook logo Twitter YouTubeLinkedIn